0,20 KG

Our price:
 Request price

Model Marvin Test Solutions: MV-GX5295
Dynamic Digital I/O with Per Channel Programmable Logic Levels & PMU PXI Card

  • 32 input / output channels
  • dynamically configurable on a per channel basis
  • 4 control / timing channels with programmable levels
  • 256 MB of on-board vector memory
  • High performance pin electronics with per channel programmability
  • Per channel parametric measurement unit (PMU)
  • Drive / sense voltage range of -2 V to + 7 V
  • 100 MHz vector rate
  • Stimulus / Response & Real-time Compare modes
  • Operates as a stand-alone card or with up to fifteen additional synchronous slave boards

The Marvin Test MV-GX5295 offers outstanding digital test capabilities and channel density in a compact 3U PXI form factor. Offering both performance digital and analog test capabilities, the MV-GX5295 provides a cost-effective, tester per pin architecture - making this card the ideal choice for high throughput, mixed-signal component test applications. Each digital channel can be individually programmed for a drive hi, drive lo, sense hi, sense lo, and load value (with commutation voltage level). In addition, each channel offers a parametric measurement unit (PMU) providing users with the capability to perform parallel DC measurements on the DUT (device under test).

The MV-GX5295 supports deep pattern memory by offering 256 MB of on-board vector memory with dynamic per pin direction control and with test rates up to 100 MHz. The board supports both Stimulus / Response and Real-time Compare modes of operation, allowing the user to maximize test throughput for go / no-go testing of components and UUTs that require deep memory test patterns. The single board design supports both master and slave functionality without the use of add-on modules.


The MV-GX5295’s pin electronic resources are independent on a per channel basis and include a full-featured PMU for DC characterization of DUTs. The PMU can operate in the force voltage / measure current or force current / measure voltage mode. In addition, the driver and receiver can be configured to support differential input and output signals from / to the UUT.

A windowing method is utilized for memory accesses, which limits the required PCI memory space for each board to only 16 MB, thus preserving test system resources. A direct mode, for continuous data transfer between the test system controller and the I/O pins of the Marvin Test MV-GX5295 is also supported.

The MV-GX5295 offers 256 MB of vector memory, with 64 Mb per channel. Programmable I/O width allows trading vector width for vector depth. Under software control, the MV-GX5295’s vector memory can be configured to support channel widths of 32, 16, 8, 4, 2 and 1 with corresponding vector depths of 64 Mb, 128 Mb, 256 Mb, 512 Mb, 1024 Mb, and 2048 Mb.

The Marvin Test MV-GX5295 provides programmable LVTTL output clocks and strobes, and supports external clock and strobe. A programmable PLL (phase locked loop) provides configurable clock frequencies and delays. Additionally, 4 additional pin electronics resources are available for use as timing and/or control resources - providing programmable drive and sense levels from -2 to +7 V.

The MV-GX5295’s sequencer can halt or pause on a defined address or loop through the entire memory as well as loop on a defined address range or through a defined block of memory. Two modes of digital test are also supported - a Stimulus / Response and a real-time compare mode. The Stimulus / Response mode is used for driving and capturing data. Alternatively, for digital tests requiring long test vectors, the real-time compare mode can be used to significantly shorten overall test times by comparing in real-time, expected test results and logging only failed vectors and resultant test results (pass or fail).

Scope of Delivery:

  • Marvin Test Solutions MV-GX5295: Dynamic Digital I/O with Per Channel Programmable Logic Levels & PMU PXI Card
  • Manual
  • Certificate of Calibration

Marvin Test Solutions

: *
: *
: *
Type the characters you see in the picture:

The code is case-sensitive and must be entered exactly as above.
Marvin Test MV-GX5295 Dynamic Digital I/O with Programmable Logic Levels & PMU PXI Card
€ 6.199,00
The cookie settings on this website are adjusted to allow all cookies so that you have the very best experience. If you continue without changing your cookie settings, we'll assume that you are happy to receive all cookies on our website. However, if you would like to, you can change your settings at any time using the Change cookie settings link in the Special menu.